Hardware installation of the PVA Removal Station

After unboxing, complete the installation of the PVA Removal Station in only a few simple steps. Make sure that all packaging material is removed from the product and choose a suitable location to install the PVA Removal Station.

Note: Always place the Ultimaker PVA Removal Station on a dry, flat and stable surface. Do not place the equipment in a humid environment.

To connect the power cable and complete the setup, take the following actions:

  1. Turn the docking station over and gently place it on a dry, flat, and stable surface.
  2. Connect the power cable to the power socket in the cavity underneath the device.
  3. Place the docking station in the upright position again.
  4. Plug the other side of the power cable into a suitable wall outlet.
  5. Gently place the container on top of the docking station.
PVARS-Install-2.jpg PVARS-Install-5.jpg
Connect the power cable to the docking station Place the container on the docking station

 

Next, we can power on the PVA Removal Station for the first time. Learn about the container illumination, or move on to filling the container with water.

Was this article helpful?
0 out of 0 found this helpful

Comments

0 comments

Please sign in to leave a comment.