ER212 - Your file could not be processed. Please provide a valid print file and do not remove the USB drive before the print is started

If you are encountering this error, then the printer has detected an invalid project file to be printed. This error likely has occurred because the file is not properly sliced for the Ultimaker 2+ Connect.

Please try re-slicing the print job in Ultimaker Cura.

Additionally, when saving the print file to USB, make sure to safely eject the drive before removing it from your computer. This prevents possible problems with corrupting data on the USB device.

When printing via USB, do not remove the USB stick from the printer until after the print job has started.

Was this article helpful?
0 out of 1 found this helpful

Comments

0 comments

Article is closed for comments.