Update the Ultimaker 2+ Connect firmware

To ensure that your Ultimaker 2+ Connect is equipped with the latest features, update the firmware to the most recent version. This can be done over the network if your printer is connected, or via USB.

Ultimaker2_Connect.JPG         

 

 

Ultimaker 2+ Connect

Download firmware

Released November, 2020

For the latest release notes, click here

Caution: When updating the firmware, do not power off the printer until the firmware installation is finished.

First installation of the firmware

Note: When booting up your Ultimaker 2+ Connect for the first time, it is possible that you will see the screen shown below. If this is the case, you must first install the latest firmware via USB before you can continue to use the printer.

Ultimaker2_Connect-steppingstone.png

If you see this screen on your Ultimaker 2+ Connect, follow these steps:

  • Download the latest firmware file via the button above
  • Place the file in the root directory of a USB stick (Note: do not make any changes to the file or filename)
  • Ensure the Ultimaker 2+ Connect is powered on and displaying the screen shown above
  • Insert the USB stick into the USB port at the front of the printer to automatically start the firmware update

Wait for the printer to finish updating the firmware. The printer will restart.

After installing the firmware according to this procedure, you are ready to complete the set-up for first use. Also download the latest version of Ultimaker Cura to ensure compatibility with your new Ultimaker 2+ Connect. For future firmware updates, follow one of the procedures listed below.

Update your Ultimaker 2+ Connect via USB

If the printer is not connected to the network, the firmware can be updated via USB. 

  • Download the latest firmware file via the button above
  • Place the file in the root directory of a USB stick (Note: do not make any changes to the file or filename)
  • Insert the USB stick in the USB port of your printer
  • Go to Settings > Update firmware, and select the new firmware in the update menu

Wait for the printer to finish updating the firmware. The printer will restart.

Update your Ultimaker 2+ Connect via the network

Connect the printer to the network via Wi-Fi or Ethernet in the Settings menu

  • Go to Settings > Update firmware
  • Select the latest firmware version to install it

Wait for the printer to finish updating the firmware. The printer will restart.

Was this article helpful?
1 out of 2 found this helpful

Comments

0 comments

Article is closed for comments.