Enable cooling fans
With this setting you can enable or disable the print head fans during printing. The print head fans ensure that the material is cooled properly before the next layer is printed. For layers with a short layer time, and those with bridges/overhangs, cooling will increase the print quality.
When the print head fans are enabled, you can adjust certain parameters. One of these is the fan speed – the speed at which the fans spin. A higher speed allows for better cooling and reduces oozing, but can also increase the shrinkage of the material. This is why the speed may be different for different materials. The preset material profiles on the Ultimaker already contain the default values for Ultimaker materials.
This setting is divided into the following parameters:
- Regular fan speed: The speed at which the fan spins before hitting a threshold. When a layer prints faster than the threshold, the speed gradually increases towards the maximum fan speed
- Maximum fan speed: The speed at which the fan spins on the minimum layer time. The fan speed gradually increases between the regular fan speed and maximum fan speed after the threshold is hit
An overview of common cooling settings combinations, projected onto a pyramid model
Regular/maximum fan speed threshold
This setting defines the layer time at which the fan will switch between regular fan speed and maximum fan speed. Layers that print slower than this time use the regular fan speed. For faster layers the fan speed gradually increases towards the maximum fan speed.
Regular fan speed at height
This is the height at which the fans will increase to full speed. In the layers below, the fan speed will gradually increase from zero to regular fan speed.
It’s also possible to change this parameter by adjusting the layer number at which the fans should be on full speed.
Using a higher value increases the adhesion to the bed, but can also lead to oozing and a reduced print quality. Printing with the fans on full from a height of 0.5 mm is usually sufficient.
Initial fan speed
This controls the fan speed on the initial layer only, which adheres to the build plate. The speed then changes back to the regular fan speed, which is achieved once it reaches the height setting for the regular fan speed.
Minimum layer time
The minimum layer time determines the time it should take to print one layer. If a layer would normally take less time than the set value, the printer slows down, so that the minimum layer time is reached. This allows the printed material to cool down properly before printing the next layer.
This is the minimum speed at which the printer is forced to print, despite slowing down to the minimum layer time. When the printer slows down too much, the pressure in the nozzle is too low and results in a bad print quality.
For example, if a minimum layer time of 5 seconds requires the printer to print at a speed of 8 mm/s, it will only do that if at least 8 mm/s is set as minimum speed. If the minimum speed is set at 10 mm/s, that means that it won’t print slower than 10 mm/s and that the layer time will change accordingly, and would then be shorter than 5 seconds.
By enabling this setting you allow the print head to move away from the print during printing, while at the minimum speed, but when it has not yet reached the minimum layer time. The print head will wait until the minimum layer time has passed and will then move back to the print to continue. This gives the printed material enough time to cool down while at the minimum speed.
Continue reading about Support settings.