How to use the CC 0.6 and 0.4 print cores

The print core CC 0.6, 0.4 and CC red 0.6 are specially designed to print with composite materials on the Ultimaker S5 and Ultimaker S3. Here you can find all information on how to use the print core. Read more about the compatibility on this page.

Using the CC print cores

Using the CC print cores is similar to using any of the other print cores on the Ultimaker S5 and Ultimaker S3. The print core can be changed, loaded, or unloaded via the configuration menu on the printer as described in the Ultimaker S5 manual and Ultimaker S3 manual.

Note:  The CC 0.4 print core has full compatibility with Ultimaker Cura 4.10 onwards and with S-line firmware 6.5 on the latest channel or 6.2.2 on the stable channel




The CC print cores are intended for use on the Ultimaker S5 and Ultimaker S3 only. Although the Ultimaker 3 uses AA and BB print cores, we strongly advise against the use of the print core CC Red 0.6 on this printer.

The reason for this is that the feeder of the Ultimaker 3 is not optimized for working with composite materials. When using composite materials on the Ultimaker 3 – even when a CC print core is installed – the ‘teeth’ of the knurled wheel inside the feeder will erode and cause unreliable material flow and under-extrusion. In the Ultimaker S5 and Ultimaker S3 feeder the knurled wheel is made from a stronger material, which means that it won’t wear when using composite materials.

Please be aware that continuing and using the CC print cores with the Ultimaker 3 is at your own risk and not officially supported by Ultimaker.

Caution: The CC 0.6 and 0.4 print cores can be used at a maximum temperature of 300°C. Although models can be sliced at higher temperatures, the print jobs will not be accepted on the printer.

Supported materials

Since the CC print cores are specifically designed for use with composite materials, it is not supported with any of Ultimaker’s own materials. Ultimaker materials are non-abrasive and can therefore be used with the standard AA or BB print cores. Composite materials of third-party material suppliers can however wear out the nozzle of the AA and BB print cores. For this reason, they should be printed with the print core CC Red.

Because of the open filament system on the Ultimaker S5 and our collaboration with several leading material companies, profiles for various third-party composite materials are provided via the Ultimaker Marketplace.

Was this article helpful?
6 out of 10 found this helpful



Article is closed for comments.