How to remove your print from the build plate

Once your 3D print is finished it must be removed from the build plate. There are several methods to use, depending on how the print is adhered to the build plate. Here’s what to do:

Wait for cool down

If you printed directly on the glass plate without using an adhesive and if the build plate was not leveled too tight, the print may easily be removed once it is cool. Simply allow the build plate and the print to cool down after printing. The material will contract as it cools and you can easily remove the print from the build plate.

Use a spatula

If your print doesn’t remove from the build plate after cooling, you will need to apply a small amount of force to remove the print. This can be done with a spatula. Place the spatula under the print and apply a small amount of force to remove the print.

Note: Take the glass plate out of the printer to avoid damage on the build plate clamps.


Use water

If neither of these methods works, remove your print using water. Remove the glass plate and print from the Ultimaker. Be careful not to burn your fingers if the glass plate is still warm. Run cool tap water on the back side of the plate to cool quickly. The print material will contract more than with normal cool down. Once cool, the print can be popped off.

If glue was used on the glass plate, run lukewarm water over the print side of the plate to dissolve the glue. Once the glue is dissolved, it is easier to remove the print. If PVA was used, place the glass plate and print in water to dissolve the PVA. This makes print removal easier.

How_to_remove_print_from_build_plate_Keep_glass_plate_under_cold_water.jpg How_to_remove_print_from_build_plate_Use_warm_water_to_dissolve_glue.jpg

Was this article helpful?
29 out of 39 found this helpful



Article is closed for comments.