Lubricate the Ultimaker 2+ axles

To make sure that your print head and Z stage are moving smoothly at all times, it is advised to periodically lubricate the axles. If the axles feel dry, this can show in your prints as small ridges on the print’s surfaces. It is recommended to apply lubrication to the axles at least once a month.

It is advised to use machine oil for lubricating the axles. This oil is specifically for the smooth axles of the Ultimaker 2+.

Caution: Only use machine oil, as using other oils or Magnalube may affect the coating of the axles, which will affect the quality of your prints.

X and Y axles

Apply a small drop of machine oil to each of the X and Y axles as well as both print head shafts. Manually move the print head around to evenly distribute the oil.

Caution: Do not apply too much oil to the axles. Doing so will increase the risk of oil dripping on to the glass plate, which will affect build plate adhesion. If any oil drops fall on to the glass, make sure to clean them thoroughly.


Z axles

Apply a small drop of machine oil to the two Z axles. In the Ultimaker menu, go to Maintenance > Advanced. Select “Raise build plate” and then “Lower build plate” to move the build plate up and down in order to evenly distribute the oil.


Was this article helpful?
13 out of 13 found this helpful



Article is closed for comments.