Replacing the blue tape on the Ultimaker 2 Go

Product notification

This product has been discontinued and the end of service has passed. The information on this page remains available, but is no longer supported.

After a lot of printing, the blue tape on the build plate may wear or damage a little bit. This can cause an uneven print surface or bad adhesion of the print. It is recommended to replace the blue tape regularly.

Instructions

Remove the glass plate

Ensure that the build plate is at the bottom of the printer. Open the two build plate clamps at the front and slide out the glass plate.

Caution: Use a hex key or screwdriver to open the clamps. They can be sharp.

Remove the old tape Peel off the old strokes old the blue tape. If certain strokes are still ok you can leave them in place, but it is recommended to replace the entire layer regularly.
Place the new tape Apply new strokes of blue tape to the build plate. Ensure to place them neatly side by side. Avoid overlaps, and minimize gaps between the strokes.
Reinstall the glass plate Slide the glass plate with the newly applied tape back into the printer until it snaps into the build plate clamps at the back. Close the front two build plate clamps to secure the glass build plate.
UM2Go-Build-plate-clamps.jpg Replace-blue-tape.jpeg UM2Go-Install-build-plate.jpg
Open the clamps with a hex key Neatly place the new tape Reinstall the glass plate

Tip: To ensure good adhesion of your next print, it is recommended to re-level the build plate after repositioning the glass plate.

Was this article helpful?
0 out of 0 found this helpful

Comments

0 comments

Article is closed for comments.