Error messages
- ER71 - Printcore EEPROM read zero
- ER70 - An expected error occurred during unloading material from bay X from extruder X
- The material failed to load wizard
- Difference between detected height of both PrintCores exceeds realistic values
- ER999 - An unspecified error has occurred
- ER998 - An unspecified error has occurred
- ER86 - Air Manager fan is unable to rotate at the desired speed
- ER80 - Expected Air Manager is missing
- ER68 - The humidity in the Material Station is high
- ER67 - Dehumidifier is not working correctly
- ER66 - Decouplers not calibrated
- ER65 - Flow sensor error
- ER64 - Cannot select / grayed out material on Material Station
- ER63 - Unknown error
- ER62 - Filament sensor error
- ER61 - Material Station failed to unload material
- ER60 - Prefeeder unable to move filament during startup
- ER59 - Material Station could not react to the Ultimaker S5 during unloading
- ER58 - Material Station could not react to Ultimaker S5 Printing
- ER57 - Material Station filament loading error
- ER56 - Printer feeder filament pickup unsuccessful
- ER55 - Filament too short for use with Material Station
- ER54 - Filament loading unsuccessful
- ER53 - Filament too short for use with Material Station
- ER52 - Decoupler obstructed
- ER51 - Filament too short for use with Material Station
- ER50 - Unexpected filament position in Material Station
- ER45 - Capacitive sensor low performance or interference detected
- ER44 - Unable to download firmware due to lack of space on printer
- ER43 - Flow sensor error