Check the Ultimaker 2+ Bowden tube

The Bowden tube guides the filament from the feeder to the print head. Over time, the inside and outside of the tube may have become scratched. This can cause print quality issues, or the tube is not held securely in place anymore.

It is recommended to check the surface quality of the Bowden tube at least once a year, or when experiencing issues, such as extrusion problems or the Bowden tubes slipping out of the feeder.

Inside of the Bowden tube

Forwarding improperly cut or ground down filament through the Bowden tube could scratch or damage the inside of the tube. If this happens, the filament can no longer be forwarded to the print head smoothly. This can lead to under extrusion or other print quality issues.

To check the tube, unload the material. To be able to inspect it better, you may have to clean the Bowden tube first. Check if you see any visible scratches on the inside of the tube.

Additionally, you can remove the Bowden tube from the print head and feeder side and push a length of filament through manually. If you feel excessive friction or obstructions somewhere along the tube, this is an indication that it should be replaced.

UM2plus-Remove-Bowden-feeder.jpg Clean-Bowden-tube.jpg

Removing the Bowden tube

 

Cleaning the Bowden tube

 

Outside of the Bowden tube

After removing a Bowden tube multiple times, the tube coupling collet can leave scratch marks on the outside of the tube. This can reduce the collet's grip on the outside of the Bowden tube. In this case, the Bowden tube can slightly move up and down during printing and retractions, which negatively impacts the print quality. It may also lead to the Bowden tube coming out of the feeder.

With the Bowden tube installed and secured with the clamp clip, pull the Bowden tube above the feeder as well as the print head. The tube should remain securely in place. If there is noticeable play (> 0.5 mm), inspect the surface more closely:

Remove the Bowden tube from the print head and feeder sides. Inspect the surface where the collets grip the tube. It is normal that there is a small ridge or line visible. However, if the surface looks very rough or worn down, it is recommended to replace the Bowden tube.

Bowden-tube-sides-L.jpeg

Replace the Bowden tubes

If you have determined that the Bowden tubes should be replaced, follow the instructions on this page.

Was this article helpful?
0 out of 0 found this helpful

Comments

0 comments

Article is closed for comments.