The Ultimaker 2+ Maintenance Kit contains the most commonly used replacement parts for the Ultimaker 2+ or Ultimaker 2 Extended+. It can be purchased in addition to your Ultimaker and used as an overall maintenance kit, or it can be used for spare parts.
Tip: Go here for the maintenance documentation of the Ultimaker 2+.
What’s included?
Below you can find an overview of all the parts that are included in the maintenance kit.
- 1x Glass plate
- 1x Bowden tube
- 1x PT100 B sensor
- 1x Heater cartridge
- 1x Grease
- 1x Machine oil
- 1x Calibration card
- 2x Build plate clamp
- 2x Clamp clip
- 2x Tube coupling collet
- 1x Hot end isolator
- 4x Olsson nozzles (0.40, 0.25, 0.60 and 0.80 mm)
- 2x TFM isolator coupler
- 1x Print head alignment aid
- 1x Hot end cooling fan
- 2x Print cooling fan
These items can be used for regular and corrective maintenance, or to perform the most likely repairs on your Ultimaker 2+. All the instructions for the repair procedures can be found on this page.
Maintenance schedule
To keep your Ultimaker 2+ in optimal condition we recommend the following maintenance schedule, based on 1,500 printing hours per year.
Every month | Every 3 months | Every year |
Clean printer | Check for play on axles | Clean feeder and replace Bowden tube |
Lubricate axles | Check tension of short belts | |
Lubricate lead screw Z motor | ||
Re-tighten hot end isolator |
Note: If the usage frequency is higher, please increase the frequency of maintenance on your machine to maintain optimal printing results.
Comments
Article is closed for comments.