1. Ultimaker Support
  2. More resources
  3. Hardware add-ons
  4. Legacy printer upgrades
  5. Olsson block upgrade for the Ultimaker 2

Setting up Cura for the Ultimaker 2

Last updated on

Note: Please visit the Ultimaker manual pages for detailed instructions.

  • Go to the “Advanced” settings tab in Cura
  • Go to the machine settings header and change the nozzle size setting to the diameter of your installed nozzle
Was this article helpful?
1 out of 76 found this helpful

Comments

0 comments

Article is closed for comments.

Articles in this section