Reattaching the Fan Bracket for the Ultimaker 2

  • If you removed the thumbscrew for easy access to the hot end isolator, reinsert it now
  • Reattach the fan bracket to the hot end, using the previously removed screws
  • The Olsson block should not touch the fan bracket at any location. If the block does touch the bracket this will result in heater errors during printing
  • Especially pay close attention to the tube of the Olsson block, which should be centered in the hole of the fan bracket. There should also be some space between the Olsson block and both the left and the bottom part of the fan bracket
Was this article helpful?
0 out of 0 found this helpful



Article is closed for comments.