Ultimaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Remove the fan bracket; it’s attached with 2 screws on either side of the hot end. During the installation procedure the fan bracket remains attached to the print head housing by the power cables
Remove the white the PTFE nozzle ring. You can find this in the hole of the fan bracket or around the nozzle
Tape the fan bracket to the print head housing to keep it out of the way during the rest of the procedure
Comments
Article is closed for comments.