How to install the front enclosure for the Ultimaker 2+

The front enclosure is one of the most effective methods of creating a stable printing environment inside your Ultimaker 2+. It will keep the warmth from the heated build plate inside the printer, resulting in a constant temperature of 45 °C.

To install the door, follow these steps:

  1. Remove the front enclosure from the packaging and hold it in front of the Ultimaker with the curved side facing down
  2. Slide the top clips behind the front panel
  3. Push the front enclosure flat against the Ultimaker, then slightly lower the door until the bottom clips hook behind the front panel

How_to_install_front_enclosure_for_Utimaker2__Slide_door.jpg How_to_install_front_enclosure_for_Utimaker2__Push_front_enclosure.jfif

After printing, to remove the door simply lift it up with your finger through the notch in the bottom and pull it towards you.


Was this article helpful?
0 out of 0 found this helpful



Article is closed for comments.