The Extrusion Upgrade kit allows you to turn your Ultimaker 2 or Ultimaker 2 Extended into an Ultimaker 2+ or Ultimaker 2 Extended+. This guide shows how to install the upgrade kit step by step. In addition to reading our detailed PDF support guide found at the bottom of this article, you can also watch this following installation guide video:
Your upgrade kit
Your upgrade kit consists of several parts. Check if all the parts are included before continuing.
- Pre-assembled print head
- Nozzle kit
- Short spool holder
- Print head shafts (X and Y)
- Hex wrench 2 mm
- Pre-assembled feeder
- Calibration card
- Build plate clamps
- Geared feeder mounting plate
- M3 ring (2x)
- M3 x 10 mm screw (6x)
- "+" stickers
- Print head axis (dis)assemble tool
- Print head alignment tools
- Feeder motor
- Grease
Comments
Article is closed for comments.