The Ultimaker 2 Extended comes in reusable, durable packaging that has been specially designed to protect your Ultimaker 2 Extended in transport. To properly unpack your Ultimaker 2 Extended, please follow the steps described below.
After having opened the cardboard box in which your Ultimaker 2 Extended was delivered the unboxing can begin. Start unpacking by taking the Ultimaker 2 Extended out of the cardboard box. You can best do this by carrying the belt and holding the cardboard box while lifting the Ultimaker 2 Extended.
Open it up
When the Ultimaker 2 Extended has been taken out of the box you can loosen the belt that’s placed around the foam packaging. This allows you to take out the Accessory box, in which you will find the quick start guide and accessories.
Removing the foam packaging
In the foam part at the front side of your Ultimaker 2 Extended you will find a spool with PLA filament and a test print done on your Ultimaker 2 Extended. Take these out and put them aside. Open up the complete packaging by removing the two foam parts at the front and the back side. Now you can take out the Ultimaker 2 Extended and place it on your desk. Make sure you hold the Ultimaker 2 Extended on the frame and don't hold it on the belts or axes while carrying it.
There is some packaging material under the build plate. You can easily remove it by lifting the build plate with your hands. At last, cut the zip tie with which the print head is secured and your Ultimaker 2 Extended is ready to use!
Supplied with your Ultimaker 2 Extended is an SD card in the 3D printer and several other accessories as well. This is everything you need to start printing.
- Power supply and cable
- Spool holder
- Glass plate
- USB cable
- Glue stick
- Hex wrenches (1.5 mm, 2 mm, 2.5 mm)
- Calibration card
- Test print
- Spare parts (hot end, PT100 sensor)