Cura software for the Ultimaker Original


Our software Cura will be used in order to set up your Ultimaker Original. Although a completely new version of Cura has just been released, we advise to use Cura version 15.04 for (setting up) the Ultimaker Original. This version contains a “configuration wizard” that helps you preparing your Ultimaker Original for the first print.


After downloading, open the installer and run the installation wizard to complete the installation. When you open up Cura for the first time, you will be asked to select the 3D printer that you have; select the Ultimaker Original. Now, Cura will automatically guide you through the “configuration wizard”.

Was this article helpful?
3 out of 6 found this helpful



Article is closed for comments.