Preparing a print file for the Ultimaker Original+

For the Ultimaker Original+, we recommend using our software Cura to prepare your 3D print files. Cura will help you converting 3D models into 3D print files within a couple of seconds and shows you a preview of the print in order to ensure everything is as you would like it to be.

Using Cura

When you use Cura for the first time you will see the Ultimaker robot model positioned on the platform. You can start converting this model into a print file, but if you want to use another model you can simply remove the Ultimaker robot model via Preferences > Clear platform or by a secondary click on the model and selecting “Delete object”.

The basic process of converting a 3D model to a print file in Cura is described below.

  • Load a 3D model (STL, OBJ, DAE or AMF file) into Cura via the “Load” button
  • Select one of the “quickprint” profiles to use a default profile for your print, or switch to the “Full settings” via Expert > Switch to full settings if you want to have more control over the settings
  • After you have done the settings and Cura has converted the file, you can save the print file (G-code file) via the “Save toolpath” button to your computer or directly on the SD card when inserted
  • At last, you can simply eject the SD card from your computer (make sure to safely remove it) and place it in the UltiController to start the print

Note: you can also use the new Cura for preparing print files for your Ultimaker Original+. We, however, advise using Cura 15.04 as it contains more configuration options for the Ultimaker Original+.

For more information on using Cura visit the Cura support pages.

Was this article helpful?
1 out of 2 found this helpful

Comments

0 comments

Article is closed for comments.