Installing the hardware accessories on the Ultimaker 2+

Placing the spool holder

  1. Take the spool holder and insert the top part into the hole in the back panel of the Ultimaker 2+
  2. Push the spool holder until it snaps into place

Installing_hardware_accessories_of_Ultimaker2__Inserting_spool_holder.jpg Installing_hardware_accessories_of_Ultimaker2__Placing_spool_holder.jpg

Placing the glass plate

  1. Open the two build plate clamps at the front of the build plate
  2. Gently slide the glass plate onto the build plate and ensure that it snaps into the build plate clamps at the back
  3. Close the two build plate clamps at the front to secure the glass plate

Installing_hardware_accessories_of_Ultimaker2__Opening_build_plate_clamps.jfif Installing_hardware_accessories_of_Ultimaker2__Placing_glass_plate.jfif

Connecting the power supply

  1. Connect the power cable to the power adapter
  2. Plug the power cable into the wall socket
  3. Connect the other side of the power supply to the Ultimaker 2+. The flat side of the connector needs to face upwards. Before you push the cable firmly into the port, you have to pull the sliding mechanism back. When the cord is in the printer you can let go to lock it into place

Installing_hardware_accessories_of_Ultimaker2__Connecting_power_supply.jpg

Was this article helpful?
2 out of 3 found this helpful

Comments

0 comments

Article is closed for comments.