Unboxing the Ultimaker 2+

The Ultimaker 2+ comes in reusable, durable packaging, specially designed to protect your Ultimaker 2+. To properly unpack your Ultimaker 2+, please follow the steps described below.

Start unpacking

Take the Ultimaker 2+ out of the cardboard box and loosen the strap by opening the buckle.

Ultimaker2__unboxing_remove_clip.jpeg

Accessory box

Take out the accessory box. In this box, you will also find the quick start guide.

Ultimaker2__unboxing_remove_accessories.jpeg

Remove the styrofoam packaging

Take the spool with PLA filament and factory test print out of the styrofoam. Then, remove the styrofoam packaging, take the Ultimaker 2+ and place it on a flat surface.

Ultimaker2__unboxing_remove_filament.jpeg Ultimaker2__unboxing_remove_styrofoam.jpeg

Remove the protection

Manually lift the build plate and remove the packaging material under the build plate. At last, cut the zip tie that secures the print head.

Ultimaker2__unboxing_lift_buildplate.jpeg Ultimaker2__unboxing_cut_zip_tie.jpeg 

This is in the box

The Ultimaker 2+ is supplied with several hardware accessories. Check if all these accessories are included before continuing.

Ultimaker2__unboxing_content_overview.png

  1. Material spool PLA (750 g)
  2. Nozzle kit
  3. Power adapter and cable
  4. Glass plate
  5. Calibration card
  6. Hex wrenches (2 mm, 2.5 mm)
  7. Spool holder
  8. Glue stick
  9. Magnalube (for lead screw Z motor)
  10. USB cable
Was this article helpful?
6 out of 6 found this helpful

Comments

0 comments

Article is closed for comments.