The complete UltiMaker S6 user manual contains all the necessary information to properly set up your new UltiMaker product and begin printing. The user manual covers all product variants and configurations:
- The UltiMaker S6 is available in two variants, with two different build plate options: a glass build plate or a flexible build plate. This user manual describes the operation for both variants, highlighting specific differences where relevant.
- The UltiMaker S6 is compatible with the optional S series add-ons: the Air Manager and Material Station. Each configuration has different workflows, which will all be covered in this user manual.
Disclaimer
This manual sets out the instructions on how to install and operate the UltiMaker S6. Please read and understand the contents of this installation and user manual carefully. Failure to read the manual may lead to personal injury, inferior print results, or damage to the UltiMaker printer or its accessories.
Always make sure that anyone who uses this 3D printer knows and understands the contents of the manual to make the most out of the UltiMaker printer.
Upon delivery of the product, installation shall be done in accordance with the instructions in this user manual. The handling, storage, use, and disposal of the device are beyond our control and are for your sole responsibility. We do not assume responsibility and expressly disclaim liability for loss, injuries, damage, or expense arising out of or in any way connected with the handling, storage, use, or disposal of the product.
The information within this document has been collected and represented with great care and is considered accurate. In case inconsistencies or inaccuracies are observed, those are unintentional and UltiMaker welcomes to be made aware of those. Submit your feedback to UltiMaker via the support case form.
This installation and user manual is available in several languages. In case of discrepancies between the original English version and the translated text, the English version is leading. Please contact UltiMaker support if you notice any inaccuracies, or in case of questions or concerns.
Downloads
Note: The translations for the UltiMaker S6 user manual are still in progress. Additional translations will be added when available.
